1MHz-1.1GHz Digital LED Frequency Counter Tester Measurement Meter For Ham Radio

Description

Home
Electronic Component
Chips
Sensor
Arduino Module
Raspberry Pi
1MHz-1.1GHz Digital LED Frequency Counter Tester Measurement Meter For Ham Radio
Popular
Popular
Product Introduction
Specification:
Use 8 bit Microchip PIC16F648A,up to 1.1GHz
Gate time
0.64 seconds
Test sensitivity
1 MHz ~ 10 MHz: superior 60mVpp
10 MHz ~ 60 MHz: superior 60mVpp
60 MHz ~ 1.1 GHz: not tested
3) . Frequency reference
5032 package 13.000 MHz Warming voltage controlled crystal oscillator ( VC - TCXO) , frequency stability is ± 2.5 ppm
IF settings
The minimum frequency is adjustable in steps of 100 Hz, frequency range 0 ~ 999.9999 MHz, can be set to plus or minus IF mode
working voltage
DC input: DC 9V ~ 12V
working current
The backlight is enabled: ≤ 55 mA backlight disabling: ≤ 55 mA
Display
maximum of 8 digit display
physical dimensions
Length * width * height: 58mm × 32mm × 27mm
Board interface
RF INPUT ( measuring signal input ): XH2.54-2P side outlet port
ICSP INPUT (MCU programming interface ): XH2.54-6P pins
POWER INPUT ( Power Interface ): XH2.54-2P side outlet port
Package included:
1 x Frequency Counter Tester Measurement For Ham Radio
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.
Home
Electronic Component
Chips
Sensor
Arduino Module
Raspberry Pi
1MHz-1.1GHz Digital LED Frequency Counter Tester Measurement Meter For Ham Radio
Product Introduction
Specification:
Use 8 bit Microchip PIC16F648A,up to 1.1GHz
Gate time
0.64 seconds
Test sensitivity
1 MHz ~ 10 MHz: superior 60mVpp
10 MHz ~ 60 MHz: superior 60mVpp
60 MHz ~ 1.1 GHz: not tested
3) . Frequency reference
5032 package 13.000 MHz Warming voltage controlled crystal oscillator ( VC - TCXO) , frequency stability is ± 2.5 ppm
IF settings
The minimum frequency is adjustable in steps of 100 Hz, frequency range 0 ~ 999.9999 MHz, can be set to plus or minus IF mode
working voltage
DC input: DC 9V ~ 12V
working current
The backlight is enabled: ≤ 55 mA backlight disabling: ≤ 55 mA
Display
maximum of 8 digit display
physical dimensions
Length * width * height: 58mm × 32mm × 27mm
Board interface
RF INPUT ( measuring signal input ): XH2.54-2P side outlet port
ICSP INPUT (MCU programming interface ): XH2.54-6P pins
POWER INPUT ( Power Interface ): XH2.54-2P side outlet port
Package included:
1 x Frequency Counter Tester Measurement For Ham Radio
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.